Scope of supply:
Wet room shower system, waste fitting with stainless steel grating with horizontal or vertical waste outlet, adjustable waste grating frame and a formwork element for the piping
Important: Subject to the requirement that the machined edges of the shower element are resealed with sealing compound, the installed can shorten the shower element by 5 cm all round.
Accessories (not included):Safety sealing tape, sealing compound, inner and/or outer corners, base element and waste extension elements
Installation sequence:STRONG></P>
1. Position shower element and mark the position of the waste trap, remove shower element
2. Lay perimeter sealing strips on the sides of the recess, insert base element up to a level of 45 + 4 mm/50 + 4 mm below the edge of the room's screed using Flex tile adhesive in the recess
3.-4. Apply the Flex tile adhesive to the surface of the base element and to the underside of the shower element
5.Insert and push on the shower element
6. Connect the waste trap with the top section
7. Align the shower element
8. Seal the junctions in the floor and wall area using a sealing system
9.-10. Insert the grating frame in the tile adhesive bed
11. Turn and slide the grating frame to align it with the tile pattern and the joints
